Sunday, August 28, 2011

Teruo Aoki et al., JGR 116 (2011), Physically based snow albedo model for calculating broadband albedos and the solar heating profile in snowpack for general circulation models


JOURNAL OF GEOPHYSICAL RESEARCH, VOL. 116, D11114, 22 PP., 2011
doi:10.1029/2010JD015507
Physically based snow albedo model for calculating broadband albedos and the solar heating profile in snowpack for general circulation models
Key Points
  • Broadband snow albedo model as function of snow parameters for GCM is presented
  • The model was validated with long-term radiation budget and snow pit work data
  • Solar heating profile in snowpack can be calculated as well
Teruo Aoki
Physical Meteorology Research Department, Meteorological Research Institute, Tsukuba, Japan
Katsuyuki Kuchiki
Physical Meteorology Research Department, Meteorological Research Institute, Tsukuba, Japan
Masashi Niwano
Physical Meteorology Research Department, Meteorological Research Institute, Tsukuba, Japan
Yuji Kodama
Institute of Low Temperature Science, Hokkaido University, Sapporo, Japan
Masahiro Hosaka
Climate Research Department, Meteorological Research Institute, Tsukuba, Japan
Taichu Tanaka
Atmospheric Environment and Applied Meteorology Research Department, Meteorological Research Institute, Tsukuba, Japan
A physically based snow albedo model (PBSAM), which can be used in a general circulation model, is developed. PBSAM calculates broadband albedos and the solar heating profile in snowpack as functions of snow grain size and concentrations of snow impurities, black carbon and mineral dust, in snow with any layer structure and under any solar illumination condition. The model calculates the visible and near-infrared (NIR) albedos by dividing each broadband spectrum into several spectral subbands to simulate the change in spectral distribution of solar radiation in the broadband spectra at the snow surface and in the snowpack. PBSAM uses (1) the look-up table method for calculations of albedo and transmittance in spectral subbands for a homogeneous snow layer, (2) an “adding” method for calculating the effect of an inhomogeneous snow structure on albedo and transmittance, and (3) spectral weighting of radiative parameters to obtain the broadband values from the subbands. We confirmed that PBSAM can calculate the broadband albedos of single- and two-layer snow models with good accuracy by comparing them with those calculated by a spectrally detailed radiative transfer model (RTM). In addition, we used radiation budget measurements and snow pit data obtained during the two winters from 2007 to 2009 at Sapporo, Hokkaido, Japan, for simulation of the broadband albedos by PBSAM and compared the results with the in situ measurements. A five-layer snow model with one visible subband and three NIR subbands were necessary for accurate simulation. Comparison of solar heating profiles calculated by PBSAM with those calculated by the spectrally detailed RTM showed that PBSAM calculated accurate solar heating profiles when at least three subbands were used in both the visible and NIR bands.

No comments:

Post a Comment